An engineering research team at the University of Alberta has invented a new transistor that could revolutionize thin-film electronic devices.
Their findings, published in the prestigious science journal Nature Communications ("Sustained hole inversion layer in a wide-bandgap metal-oxide semiconductor with enhanced tunnel current"), could open the door to the development of flexible electronic devices with applications as wide-ranging as display technology to medical imaging and renewable energy production.
The team was exploring new uses for thin film transistors (TFT), which are most commonly found in low-power, low-frequency devices like the display screen you're reading from now. Efforts by researchers and the consumer electronics industry to improve the performance of the transistors have been slowed by the challenges of developing new materials or slowly improving existing ones for use in traditional thin film transistor architecture, known technically as the metal oxide semiconductor field effect transistor (MOSFET).
But the University of Alberta electrical engineering team did a run-around on the problem. Instead of developing new materials, the researchers improved performance by designing a new transistor architecture that takes advantage of a bipolar action. In other words, instead of using one type of charge carrier, as most thin film transistors do, it uses electrons and the absence of electrons (referred to as "holes") to contribute to electrical output. Their first breakthrough was forming an “inversion” hole layer in a “wide-bandgap” semiconductor, which has been a great challenge in the solid-state electronics field.
Once this was achieved, "we were able to construct a unique combination of semiconductor and insulating layers that allowed us to inject ‘holes’ at the MOS interface," says Gem Shoute, a PhD student in the Department of Electrical and Computer Engineering who is lead author on the article. Adding holes at the interface increased the chances of an electron "tunneling" across a dielectric barrier. Through this phenomenon, a type of quantum tunneling, "we were finally able to achieve a transistor that behaves like a bipolar transistor."
"It's actually the best performing [TFT] device of its kind--ever," says materials engineering professor Ken Cadien, a co-author on the paper. "This kind of device is normally limited by the non-crystalline nature of the material that they are made of."
The dimension of the device itself can be scaled with ease in order to improve performance and keep up with the need of miniaturization, an advantage that modern TFTs lack. The transistor has power-handling capabilities at least 10 times greater than commercially produced thin film transistors.
Electrical engineering professor Doug Barlage, who is Shoute's PhD supervisor and one of the paper's lead authors, says his group was determined to try new approaches and break new ground. He says the team knew it could produce a high-power thin film transistor — it was just a matter of finding out how.
"Our goal was to make a thin film transistor with the highest power handling and switching speed possible. Not many people want to look into that, but the raw properties of the film indicated dramatic performance increase was within reach," he says. "The high quality sub 30 nanometer (a human hair is 50 nanometers wide) layers of materials produced by Cadien's group enabled us to successfully try these difficult concepts"
In the end, the team took advantage of the very phenomena other researchers considered roadblocks.
"Usually tunneling current is considered a bad thing in MOSFETs and it contributes to unnecessary loss of power, which manifests as heat," explains Shoute. "What we've done is build a transistor that considers tunneling current a benefit."
The team has filed a provisional patent on the transistor. Shoute says the next step is to put the transistor to work "in a fully flexible medium and apply these devices to areas like biomedical imaging, or renewable energy."
Release Date: February 9, 2016
Source: University of Alberta