MANY CLIENTS WHO ARE INVOLVED IN CRITICAL CLEANING tell us that they are on a perennial hunt for plasticizers. As consultants, we have to advise them that the likelihood of totally eliminating plasticizers is nil. We can, however, assure them (and you) that it is certainly feasible to minimize plasticizer contamination. Plasticizers (usually phthalates) are chemical additives that impart flexibility to polymers used in such equipment as laboratory squeeze bottles and hoses. Plasticizers dissolve in solvents to become a perennial contaminant of cleaning agents. Potentially, they can be deposited as non-volatile residue (NVR) on critical components [1] thus negating the critical cleaning application.

Solvent Storage
It is helpful to think of solvent storage and management as a process rather than a static situation, in that heat, agitation, and time, influence the amount of plasticizers dissolved. While specific management tactics are solvent-specific, a basic strategy involves minimizing sources of plasticizers in anything that comes in contact with the solvent. This effort begins with the vendorand continues at the user facility.

The Solvent Vendor
The first step is to have a vendor with an appreciation of plasticizers, a desire to minimize them, and a willingness to communicate with you. Transfer equipment and storage conditions impact the level of plasticizers. Pails, pumps, tubing, stirrers, all can introduce contaminants. One supplier we worked with found that plasticizers were leaching from “chemical resistant” tubing. They solved the problem by switching to stainless steel and glass transferequipment.

Your Facility
Transfer equipment
Transfer equipment such as pumps should be selected to be as non-reactive with the solvent as possible. Facilities people need to be made aware of the requirement to use only the specified equipment; it is very tempting to make a randomsubstitute based on cost or expediency.

Storage containers
For very high-end applications, with critical cleaning requirements, it is preferable to store solvents in glass; depending on potential reactivity of the solvent, dark glass may be preferable. This is particularly true for solvents used at the final cleaning stages. Even if the bottle is glass, there is a seal that can contain plasticizers. The choice of seal materialcan be a critical parameter.

Glass is preferable, even for bench top cleaning applications. Soft plastic bottles should certainly be avoided. For example, extraction of plasticizers into isopropyl alcohol stored in small plastic squeeze bottles is a recurrent problem, even if the alcohol in the squeeze bottles is totally replaced at periodic intervals.

Polyethylene is generally preferable to polypropylene. Plastics from different sources can show subtle variations; and there can be lot to lot variations. It is therefore reasonable to obtain detailed compatibility information from the solvent vendor and the supplier of the containers.

Commercial, prepackaged aerosol/sprays
Because they are used for a limited period and then replaced, prepackaged products avoid the issue of plasticizer buildup due to gradual degradation of spray bottles. They can be useful, if they are carefully selected and monitored. Again, this requires careful partnering with the supplier. Plasticizer contamination has been observed when a vendor substituted a new “nozzle extender.” The problem was detected by routine FTIR; the vendor was notified, and appropriatesubstitutions were made.